In the use of automatic labeling machine, there will always be more or less encountered many problems, of which the most common faults there are three, the following to share with you when these three labeler failure How to quickly and effectively solve.

After the label is creased

1, delivery rate faster than the material surface line speed, transfer the standard rate can be small
2, the bid too early, the measured object can move to the right eye
3, pre-label too long, small pre-standard length can be adjusted
4, the label speed is not fast enough, you can increase the label speed

Can not be labeled

1, the standard rate is too slow, increase the standard rate can be
2, the measurement of electric eye position is not correct, adjust the measurement of electric eye position
3, pre-label is not long enough, adjust the length of the label can be reserved
4, the measured object electric eye is too far from the end of the standard, the measured object electric eye can move to the right
5, Electroscope does not detect the material object, adjust the electrical eye can be measured
6, spacing between materials is too small, increasing the distance between materials can be

Labeling machine can not label

1, the measured object electric eye position is not correct, adjust the position of the electric eye can be measured
2, the measured electrical eye failure, electrical eye can replace the test material
3, labeling the first label is not enough paper, pull the paper can be adjusted tight
4, the paste color can not be electric eye sensor, replace the function of the appropriate type of electric eye can
5, the dispenser does not open, open the dispenser can be